Vanderbilt SPC4 Series Installation & Configuration Manual page 294

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
Trigger
States, Outputs, Events, or Communications
condition
User Wireless Fob – this condition can be configured for a particular user or for any user. With this
configuration, if the configured user (or any user) presses the '*' key on the FOB, it will cause an
instantaneous pulse OFF/ON/OFF. This only applies for FOBs that have been registered with
the system.
Wireless Fob Panic – this condition can be configured for a particular user or for any user. With
this configuration, if the configured user (or any user) presses the '*' key on the FOB Panic, it
will cause an instantaneous pulse OFF/ON/OFF. This only applies for FOB Panics that have
been registered with the system.
Keypad Pin – this condition can be configured for a particular user or for any user. With this
configuration, if the configured user (or any user) enters a valid PIN, or presents a configured
PACE, it will cause an instantaneous pulse OFF/ON/OFF.
Access card – the trigger is activated when the selected user logs in using an access card.
Web Access – the trigger is activated when the selected user logs in through the web browser.
WPA* – the trigger is activated if a button or combination of buttons is pressed. It is possible to
assign a trigger condition to all WPAs or just to one specific WPA. When a trigger with a WPA
trigger condition is defined, it can be assigned to a mapping gate for many purposes including
arming a system, turning on lights or opening a door.
Keypad Access – the trigger is activated when any user logs into the selected keypad.
Profile Keypad Pin – if a user with the configured user profile enters a valid PIN, or presents a
configured PACE, it will cause an instantaneous pulse OFF/ON/OFF.
Access card – the trigger is activated when a user with the configured user profile logs in using
an access card.
Web Access – the trigger is activated when a user with the configured user profile logs in
through the web browser.
Expander Keyswitch – the trigger can be configured for a specific key position on the keyswitch.
Indicator – the trigger can be configured for a specific function key.
Communication FlexC ATP – the trigger activated by the selected ATS and ATP configuration.
FlexC ATS – the trigger activated by the selected ATS configuration.
*A WPA is compatible with SiWay RF Kit (SPCW110, 111, 112, 114 ) only.
WARNING: Your system will not comply with EN standards if you enable a trigger to set the system
without a valid PIN being required.
17.10.7.4 Audio/Video Verification
To set up Audio/Video Verification on an SPC system:
1. Install and configure Audio Expander(s).
2. Install and configure Video Camera(s).
3. Install and configure Audio Equipment.
4. Configure Verification Zone(s).
5. Test audio playback from verification zones.
6. Assign Verification Zone(s) to physical zone(s).
© Vanderbilt 2018 294
Engineer programming via the browser
A6V10276959-d
12.09.2018