Vanderbilt SPC4 Series Installation & Configuration Manual page 380

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
CODE CID EVENT
300 SYSTEM TROUBLE
301 AC LOSS
302 BATTERY LOW
305 RESET
311 BATTERY FAIL
312 PSU OVERCURRENT
320 SOUNDER
330 SYSTEM PERIPHERAL
TROUBLE
333 EXP FAIL
338 EXP BATT
341 EXP TAMPER
342 EXP AC
344 RF JAM
351 TELCO 1
352 TELCO 2
376 HOLDUP TROUBLE
380 SENSOR TROUBLE
401 OPENCLOSE
406 ALARM ABORT
451 EARLY OPENCLOSE
452 LATE OPENCLOSE
453 FAIL TO OPEN
454 FAIL TO CLOSE
456 EVENT PARTSET
461 CODETAMPER
466 SERVICE
570 BYPASS
601 MANUAL TEST
602 AUTO TEST
607 WALK TEST
© Vanderbilt 2018
DESCRIPTION
PSU fault and restore.
PSU mains fail and restore.
System reset.
PSU battery fail and restore.
PSU internal, external and auxiliary fuse fail and restore.
Bell tamper fail and restore.
PSU fault and restore.
X-Bus cable and node communications fault and restore.
X-Bus node battery fault and restore.
X-Bus tamper and RF antenna tamper alarm and restore.
X-Bus node mains fault and restore.
RF jam fault and restore.
Primary modem fault and restore.
Secondary modem fault and restore.
Unset, post alarm and fullset.
Cancel alarm.
Late to unset.
Late to set.
Partset A and B.
User code tamper.
Engineer mode enabled and disabled.
Zone inhibited and uninhibited, zone isolated and un-isolated.
Modem manual test.
Modem automatic test.
380
Appendix
A6V10276959-d
12.09.2018