Vanderbilt SPC4 Series Installation & Configuration Manual page 274

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
1. Select Configuration > Areas > Areas.
The following page will be displayed:
2. Click Edit to edit an existing area.
3. Click Add to add a new area. If the Installation Type is Domestic or Commercial, an area is
automatically added and the Edit Area Settings page is displayed.
Note that the area type for the new area is automatically set to Standard.
If the Installation Type is Financial, the following page is displayed and the area must be added
manually.
4. Enter a description for the new area and select an area type from one of the following:
- Standard – Suitable for most areas.
- ATM – Provides settings and defaults relevant to ATMs.
- Vault – Provides settings and defaults relevant to vaults.
- Advanced – Provides all area settings (Standard, ATM and Vault).
5. Click the Add button to add the area.
Configure the settings for each installation type as per the following sections.
Entry/Exit
Configure the following Entry/Exit settings:
Entry time The time period (in seconds) allowed for the user to UNSET the alarm after opening an entry/exit
zone of an armed system. The entry time applies to all entry/exit zones in that area (default: 45
seconds).
© Vanderbilt 2018 274
Engineer programming via the browser
A6V10276959-d
12.09.2018