Vanderbilt SPC4 Series Installation & Configuration Manual page 350

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
3. Enter Engineer programming from the keypad and configure the modem (primary or backup) to
answer an incoming call.
4. On the keypad, scroll to Full Engineer Mode > Comms > Modems.
5. Select the following settings:
- Enable Modem: Set to enabled
- Type: Displays the type of modem (PSTN)
- Country Code: Select the relevant country code (Ireland, UK, Europe)
- Answer mode: Select numbered rings; this tells the modem to wait for a number of rings before
answering the incoming call
- Modem Rings: Select the number of rings to allow before answering the call (8 rings max)
6. Create a dial-up connection on the remote PC using the phone number of the telephone line
connected to the PSTN module on the controller. The instructions to do this on Windows XP
operating system are listed below.
On Windows XP:
1. Open the New Connection Wizard by browsing to Control Panel > Network Connections >
Create New Connection (in the Network Tasks page).
2. On the Network Connection Type page, select Connect to the Internet.
3. On the Getting Ready page, choose Setup my connection manually.
4. On the Internet Connection page, choose Connect using Dialup modem.
5. On the Connection Name page, enter the connection name, for example, SPC remote connection.
6. On the Phone Number to Dial page, enter the phone number of the PSTN line connected to the
PSTN modem.
7. On the Connection Availability page, choose whether this connection is available to all users.
8. On the Internet Account Information page, enter the following details:
- Username: SPC
- Password: password (default)
- Confirm Password: password
The Completing the New Connection Wizard page is displayed.
9. Click Finish to save the Dial-up connection to the PC.
Default code should be changed and noted accordingly as Vanderbilt is unable to retrieve this new
code. Forgotten codes are be remedied only by a factory default of the system, rendering loss of
programming. Programming can be restored if a backup is available.
To activate this dial-up connection:
Click the icon located in the Control Panel > Network Connections page.
l
The PC makes a data call to the PSTN line connected to the SPC PSTN module.
The SPC PSTN module answers the incoming data call after the designated number of rings and
establishes an IP link with the remote computer.
The SPC system automatically assigns an IP address to the remote PC.
© Vanderbilt 2018 350
Accessing web server remotely
A6V10276959-d
12.09.2018