Vanderbilt SPC4 Series Installation & Configuration Manual page 119

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
Timer Description
Strobe on Activates the strobe on the external bell momentarily to indicate a full set condition.
Fullset (0–10 seconds)
FULLSET
STROBE
Alarm
Double Knock The maximum delay between activation's of zones with the double attribute, which
will cause an alarm. (1–99 seconds)
DKNOCK
DELAY
Soak The number of days a zone remains under soak test before it automatically returns to
normal operation. (1–99 days)
SOAK DAYS
Seismic Test The average period between seismic sensor automatic tests. (12–240 hours)
Interval
Note: To enable automatic testing, the Automatic Sensor Test attribute must be
SEISMIC enabled for a seismic zone.
AUTOTEST
Seismic Test Maximum time (in seconds) that a seismic sensor takes to trigger an alarm in
Duration response to the 'Seismic Test' output. (3–120 seconds)
SEISMIC TEST
DUR
Auto Restore Time to delay auto restore after zone state returns to normal. (0–9999 seconds)
Delay
Lockout Post The duration of time after an alarm before the user can gain access. (1–120 minutes)
Alarm
LOCKOUT
POST ALARM
Access Time The duration of time the system can be accessed by an alarm access user after the
Lockout Time has elapsed. (10–240 minutes)
External Bell Duration that the strobe output will be active when an alarm is activated. (1–999
Strobe minutes; 0 = indefinitely)
STROBE TIME
Alerts
Mains Delay The time after a mains fault has been detected before an alert is activated by the
system. (0–60 minutes)
MAINS SIG
DELAY
RF Jamming The time after RF Jamming has been detected before an alert is activated by the
Delay system. (0–999 seconds)
© Vanderbilt 2018 119
Engineer programming via the keypad
Default
0sec.
10sec.
14 days
168
hours
30sec.
0sec.
0min.
15min.
0min.
0min.
A6V10276959-d
12.09.2018