Vanderbilt SPC4 Series Installation & Configuration Manual page 162

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
ACCOUNT
NAME
PROTOCOL The communication protocol to be used (SIA, Contact ID, Fast Format).
1ST PHONE
NUMBER
2ND
PHONE
NUMBER
PRIORITY
4. After programming is complete, the option to make a test call to the station is displayed on the
keypad.
16.13.4.2 Edit
To edit the central station settings:
1. Scroll to CENTRAL STATION > EDIT.
2. Press SELECT.
3. Select the desired programming option shown in the table below.
ACCOUNT
ID
ACCOUNT
NAME
PROTOCOL
1ST PHONE
NUMBER
2ND PHONE
NUMBER
DIAL
ATTEMPTS
DIAL
INTERVAL
ASSIGN
AREA
REPORTED
EVENTS
PRIORITY
AUTOMATIC
TEST
4. After programming is complete, the option to make a test call to the station is displayed on the
keypad.
© Vanderbilt 2018
Description of the Remote Alarm Receiving Centre.
The first number to be dialled to contact the ARC.
The second number to be dialled to contact the ARC; the system only attempts
to contact the ARC on this number if the first contact number did not
successfully connect.
The modem (primary or back-up) to be used to communicate with the ARC.
This information should be available from the receiving station and is used
to identify users each time a call is made to the ARC.
Description of the Remote Alarm Receiving Centre.
The communication protocol to be used (SIA, Contact ID, Fast Format).
The first number to be dialled to contact the ARC.
The second number to be dialled to contact the ARC; the system only
attempts to contact the ARC on this number if the first contact number did
not successfully connect.
Enter the number of times that the system will attempt to make a call to the
receiver.
Enter the number of seconds to delay between failed dial attempts. (0–999)
Assign the areas for which events are reported to the ARC.
Define the types of events reported to the ARC.
The modem (primary or back-up) to be used to communicate with the ARC.
Defines a schedule for testing the connection to the ARC. Possible values
range from every hour to once every 30 days.
162
Engineer programming via the keypad
A6V10276959-d
12.09.2018