Vanderbilt SPC4 Series Installation & Configuration Manual page 136

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
ACCESS
CONTROL
LANGUAGE
16.7.2.1 Access Control
One access card can be assigned to each of the users on the control panel.
To configure the access control for a user:
1. Scroll to USERS>EDIT.
2. Press OK.
3. Select the user which should be configured and press OK.
4. Scroll to ACCESS CONTROL and press OK.
The following sections provide programming steps found within the access control option of the
selected user.
Add Card manually
If the card format of the card number is known, the card can be created manually.
The site code of the card is configured for the user profile that is assigned for this user.
1. Scroll to ADD CARD.
2. Press OK.
An empty card has been added and can now be edited.
Learn Card
NOTICE: Only cards with supported card formats can be learned.
If the card number or the card format is not known, the card can be read and its information learned.
1. Scroll to LEARN CARD.
2. Press OK.
3. Select the door that the card will be presented.
4. Press OK.
© Vanderbilt 2018
If no card assigned to the user:
ADD CARD
l
LEARN CARD
l
If a card assigned to the user:
EDIT CARD
l
– CARD NUMBER
– CARD ATTRIBUTES
RESET CARD
l
DELETE CARD
l
Select a language for this user that will be displayed on the system.
NOTICE: The new card can be presented at the entry or the exit reader of the
selected door.
136
Engineer programming via the keypad
A6V10276959-d
12.09.2018