Vanderbilt SPC4 Series Installation & Configuration Manual page 176

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
9. On the last dialog of the wizard, click Finish.
10. The PC prompts for username and password for the USB connection. Enter the following details:
- Username: SPC
- Password: password (default)
11. Click Connect.
The PC initiates a data link with the controller. When the link has been established, a connection
icon appears on the task bar at the bottom of the PC screen.
12. Right-click the link and select Status.
A server IP address is displayed in the details window.
13. Enter this address into the address bar of an internet browser using the hyper text transfer protocol
secure (for example, https://192.168.5.1).
14. Login into the SPC browser application using your user PIN.
Your default PIN should be changed immediately and noted. Forgotten PINs are remedied only by a
factory default of the system, resulting in a reset of the system configuration. The configuration can
be restored if a backup is available.
Windows 7
Prerequisites
You must have Local Administrator rights to perform the actions in this task.
o
1. Open the Windows 7 Control Panel.
2. Select Phone and Modem.
The Phone and Modem page is displayed.
3. Select the Modems tab and click Add.
The Add Hardware Wizard – Install New Modem page is displayed.
4. Click Next twice.
The Add New Hardware wizard displays a list of modems.
5. Select Communications cable between two computers.
6. Click Next.
7. Click Next, then Finish.
8. Return to the Modems tab of the Phone and Modem page.
9. Select the new modem and click Properties.
The Communications cable between two computers Properties page is displayed.
10. In the General tab, click Change Settings to allow editing of the properties.
11. Select the Modem tab.
12. Change the value in the Maximum Port Speed to 115200 and click OK.
13. From the Control Panel, open the Network and Sharing Center.
14. Click Change Adapter Settings. If a new modem is present in the list of available connections,
proceed to step 22. If the modem is not present, perform the following steps.
15. In the Network and Sharing Center, click Set up a new connection or network.
16. Select Set up a dial-up connection and click Next.
© Vanderbilt 2018 176
Engineer programming via the browser
A6V10276959-d
12.09.2018