Vanderbilt SPC4 Series Installation & Configuration Manual page 295

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
7. Configure Verification Settings.
8. View images from verification zones in web browser.
NOTICE: Keypads and access control may be disabled for several minutes while sending an
audio file to the panel, depending on the size of the file.
Configuring Video
Overview
Cameras are used for video verification. The SPC panel supports a maximum of four cameras. Only IP
cameras are supported and the panel must have an Ethernet port.
NOTICE: Cameras must not be shared with other CCTV applications.
Cameras can only be configured with the web browser. Configuration with the keypad is not supported.
The panel supports two camera resolutions:
320X240
l
This setting is recommended if you want to view images on the browser)
640X480 (with some restrictions).
l
The following cameras are supported in addition to other generic cameras:
Vanderbilt CCIC1410 (1/4" VGA IP Colour Camera)
l
Vanderbilt CFMC1315 (1/3" 1.3 MP Indoor Dome Colour Camera)
l
A command string is available as a default to access configuration details for the above cameras
directly. Other generic IP cameras require a command string to be entered manually.
Adding Camera
1. Select Configuration > Advanced > Verification > Video.
A list of any previously configured cameras is displayed and their online or offline status. A
camera is online if an image was obtained from the camera in the previous 10 seconds.
2. Click the Add button to add a new camera or the Edit button to edit an existing camera.
The following page is displayed.
© Vanderbilt 2018 295
Engineer programming via the browser
A6V10276959-d
12.09.2018