Vanderbilt SPC4 Series Installation & Configuration Manual page 268

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
Timer Description
PIN Changes Number of changes within a valid period. (1–50)
Limit
PIN CHANGES
LIMIT
PIN Warning Time before PIN expiry after which a warning will be displayed. (1–14 days)
PIN WARN
General Settings
RF Output Time The time that the RF output will remain active on the system. (0–999 seconds)
RF OUTPUT
Time Sync Limit Time limit within which time synchronization will not take place. Time
synchronization only takes place if system time and update time are outside this
TIME SYNC
limit. (0–300 seconds)
LIMIT
Link Timeout Timeout for Ethernet link fault. (0–250 seconds; 0 = Disabled)
LINK TIMEOUT
Camera Offline Time for camera to go offline. (10–9999 seconds)
CAMERA
OFFLINE
Frequent This attribute only applies to remote services. The number of hours within which a
zone must open if the zone is programmed with the Frequent attribute. (1–9999
FREQUENT
hours)
Duress silent Time when duress will remain silent and not restorable from keypad. (0–999
minutes)
Holdup/panic Number of minutes that a holdup/panic will remain silent and cannot be restored
silent from the keypad. (0–999 minutes)
Default times are dependent upon the Engineer configuration. The default times denoted may or may
not be allowable and is dependent on the configuration by the engineer.
Valid settings/ranges may be dependent on the security grade specified under Configuration >
System > Standards.
17.10.3.3 Identification
1. Select Configuration > System > Identification.
The following page will be displayed.
© Vanderbilt 2018 268
Engineer programming via the browser
Default
5
5 days
0sec.
0sec.
0sec.
10sec.
336h (2
weeks)
0min.
0min.
A6V10276959-d
12.09.2018