Vanderbilt SPC4 Series Installation & Configuration Manual page 326

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
1. To configure an Event Exception Definition, complete the fields described in the table below.
Identification
Name
Event ID
Event
Description
Event Filter
Report Event
Filter
Exception
Enable
if (0 ≤ Zone ID
≤ 9999)
then Report
Event/Don't
Report Event
Event Format
SIA Event
Code
Contact ID
Event
Code/Qualifier
Remap
Exception
Enable
if (0 ≤ Zone ID
≤ 9999)
then Remap
SIA Event
Code to BA
and Remap
Contact ID
Event
Code/Qualifier
to
© Vanderbilt 2018
Enter the name of the Event Exception.
Event ID of the event on the system. This is display only.
Description of the event. This is display only.
Check to report the event. This overrides the reporting value set for the event
Filter Group. For example, if the Filter Group Intruder Alarms is set to report,
you can exclude the BA event or by disabling this setting.
Check to exclude a range of addresses, for example Zone IDs, from the
Report Event field setting.
Enter a range of addresses to exclude from the Report Event setting. For
example, if you choose to report the event type BA, you may choose not to
report Zone ID 1 - 9 for that event.
Alternatively, if you choose not to report the event type BA, you may choose
to report Zone ID 1- 9 for that event.
Default SIA event code that is transmitted to represent the event. This field is
display only.
Default Contact ID Event Code/Qualifier transmitted to represent the event.
This field is display only.
Check to remap the default SIA, CID code/Qualifier and Event Address to
customised values, for example, to remap Zone ID 1 - 9 to Zone ID 101 - 109.
When enabled, the fields below display.
Enter the range of addresses to remap for an event, for example, if you want
to remap Zone ID 1 - 9 to Zone ID 101 - 109, enter 1 and 9. The quantity of
addresses in the range must be equal to the quantity of addresses defined in
the field Remap Event Address below.
Remap the default SIA code to a customised SIA code.
Remap the default CID Event Code/Qualifier to a customised CID Event
Code/Qualifier.
326
Engineer programming via the browser
A6V10276959-d
12.09.2018