Vanderbilt SPC4 Series Installation & Configuration Manual page 239

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
17.10.1.3 Configuring system latch and auto set outputs
1. Under Policy, click the Edit button for the Output Configuration option in System Options.
The following page is displayed:
2. Select the condition under which the latch output is activated:
Entry Time
Fire Exit
Unset
Alarm Reset
Resetting
Alarm
Engineer Exit
Keypad Valid
PIN
3. Select the behavior of the output.
On
Keypad
Progressive
Pulse Time
© Vanderbilt 2018
Output turns on at the end of Exit time and off at the beginning of Entry
time.
Output turns on if any fire exit zones are active.
Output turns on if any user unsets system momentary
Output turns on if an alarm is reset momentary.
Output turns on during a setting procedure if glass break/smoke open and
not in alarm.
Output turns on when an engineer exits from Engineer mode momentary.
Output turns on when valid user PIN entered on keypad and fire zone is
active
Output will remain on if auto set is active.
Output will follow keypad operation.
Output will give progressive warning of auto set.
Select the duration that the auto set output will remain active when pulsed.
239
Engineer programming via the browser
A6V10276959-d
12.09.2018