Vanderbilt SPC4 Series Installation & Configuration Manual page 233

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
Input zones: attributes
Each zone on the SPC can be assigned an attribute that determines the properties of that zone.
To assign an attribute to a zone:
1. Select Configuration > Hardware > Controller > Attributes.
The following page will be displayed:
2. Check the box beside the preferred attribute.
The attributes presented on this page will depend on the type of zone selected. For a list of
assignable attributes, see Applicable attributes to zone types on page 393.
17.10.1.2 Editing an output
1. Select Configuration > Hardware > Controller.
© Vanderbilt 2018 233
Engineer programming via the browser
A6V10276959-d
12.09.2018