Vanderbilt SPC4 Series Installation & Configuration Manual page 242

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
3. Configure the following fields:
Description
Volume
Limit
Auxillary
Channnel
End Of Line
(Zone)
Description
(Zone) Type Select the zone type. See Zone attributes on page 390.
Area
Attributes
Outputs/PSU outputs (Displayed for the SPCP355.300 Smart PSU ONLY)
Output
Description
Change
type
Attributes
Test
© Vanderbilt 2018
For appearance on device LEDs.
Audio Expander Only: Speaker volume for the Audio Expander and satellites
(WAC 11). They are all wired in parallel. Note that the speaker on WAC 11 has a
potentiometer for fine-tuning the volume. Range is 0 min – 7 max or disabled.
Audio Expander Only: This option should be enabled if satellites (WAC11) are
connected to this expander.
Note: This option, if enabled, powers the satellite microphones. The satellite
speakers are always enabled regardless of this setting.
Select the correct End of Line (default: DEOL 4K7). This setting should match
the actual wiring of the input on the controller or expander. See Wiring the
system on page 75.
Provide a description for allocated zone.
Select the area.
Assign attributes as desired. See Zone types on page 385.
The numbered output. The value in parentheses corresponds to the physical
output on the PSU board.
Provide description for output.
Change the type of output as necessary.
Assign attributes to the output.
Test the output.
242
Engineer programming via the browser
A6V10276959-d
12.09.2018