Vanderbilt SPC4 Series Installation & Configuration Manual page 273

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
1. Select Configuration > Inputs > All Zones.
The following page will be displayed.
2. Configure the fields as described in the table below.
Zone
Description Enter a text (max. 16 characters) that serves to uniquely identify the zone.
Input
Type
Area
Calendar
Attributes
17.10.4.2 Adding/Editing an area
Prerequisite
Only if (multiple) Areas is activated.
o
© Vanderbilt 2018
You can select Configuration > Inputs > X-Bus Zones to configure wired
zones only or Configuration > Inputs > Wireless Zones to configure
wireless zones only.
The number is presented for reference and can not be programmed.
The physical input is displayed for reference and is not programmable.
Select a type of zone from the drop down menu (see Zone types on page 385).
Only if (multiple) Areas is activated. Select an area to which the zone is
assigned from the drop down menu.
Select if necessary the desired calendar (see Calendars on page 287).
For Security Grade 2/3 a calendar can be assigned only to zones of type Exit
Terminator, Technical, Key Arm, Shunt and X-Shunt. For Security Grade
Unrestricted a zone of any type can be associated with a calendar.
Tick the relevant checkbox for the zone. Only attributes that apply that type of
zone will be presented (see Zone attributes on page 390).
273
Engineer programming via the browser
A6V10276959-d
12.09.2018