Vanderbilt SPC4 Series Installation & Configuration Manual page 338

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
2. Configure the fields as described in the table below.
Check any of the following boxes if you want to initiate a remote call to an EDP Receiver to notify it
of the particular event.
Alarms
Alarm
Restores
Confirmed
Alarms
Alarm Abort
Faults
Fault
Restores
Zone state
© Vanderbilt 2018
Alarms are activated.
System alarms are restored.
Alarms confirmed by multiple zones
Alarm Abort events. Alarms are aborted after a valid user code is entered via the
keypad after a confirmed or unconfirmed alarm,
Faults and tampers are activated.
Fault or tamper alarms are restored.
Report all zone input state changes.
338
Engineer programming via the browser
A6V10276959-d
12.09.2018