Vanderbilt SPC4 Series Installation & Configuration Manual page 187

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
Panic Keypad panic alarm status.
Fire Keypad Fire alarm status.
Medical Keypad medical alarm status.
Code Tamper Keypad PIN tamper alarm status
Performable actions
Restore Click the button to restore all alerts on the panel.
Alerts
Inhibit Click this button to inhibit a fault condition. The inhibit operation will disable that fault or zone for one
arming period only.
Inhibit operation is not available in Security Grade EN 50131 Grade 3.
Isolate Click this button to isolate that zone. Isolating a zone will de-activate that zone until such time as the
zone is explicitly de-isolated again. It is recommended that you exercise caution when isolating
zones as those zones will not be active every time the system is SET.
17.6.2.4 Door Controller Status
1. Select Status > Hardware > X-Bus Status.
2. Select the Door Controllers tab.
A list of detected door controllers is displayed.
Name
Expander ID
Description
Type
S/N
Version
Comms
Status
PSU
Performable actions
Refresh Click the Refresh button to update the status of the system alerts.
To view more status information:
Click a door controller's identifying parameters (ID, description, type, serial number) to display
l
further status details.
© Vanderbilt 2018
Description
This ID number is a unique identifier for the door controller.
Text description of the door controller (max. 16 characters).
The type of expander detected (=door controller).
The serial number of the door controller.
The firmware version of the door controller.
The status of the door controller (online or offline).
The status of the door controller (OK, Fault).
Specifies if the door controller has a PSU.
187
Engineer programming via the browser
A6V10276959-d
12.09.2018