Vanderbilt SPC4 Series Installation & Configuration Manual page 261

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
System
Restriction
Option
Keypad
Always Show
State
(SHOW
STATE)
Show Open
Zones
Call ARC
Message
Call ARC Line
1
Call ARC Line
2
Show Cameras
Log Keypad
Access
Idle State
Language
Use Simplified
Menu
PIN
PIN Digits
PACE and PIN
© Vanderbilt 2018
Description
If enabled, the setting status of the system (Fullset/Partset/Unset) is
permanently displayed in the bottom line of the keypad display. If unchecked
the setting status will disappear from the keypad display after 7 seconds.
If enabled, open zones will display on keypad in Unset mode.
If enabled, the ARC message will be displayed for 30 seconds after Unset, if
confirmed alarm has been reported.
ARC message in line 1 of display (16 chars).
ARC message in line 2 of display (16 chars).
If enabled, offline cameras will be displayed on the keypad in Unset mode.
Enable this option to log users' keypad access (successful and failed log-in
attempts).
Select the language displayed in idle state.
System Language: Language in which menus and texts on the keypads,
l
the web interface and the event log will be displayed.
Last Used: Last used language is displayed in idle state.
l
Enable this option to use simplified set/unset menus on the 'Comfort' and
'Compact' Keypads (for one area configuration only).
Enter the number of digits for user PINs (max. 8 digits). Increasing the number
of digits will add the relevant number of zeros to the front of an existing PIN, for
example, an existing user PIN of 2134 (4 digits) will change to 00002134 if the
PIN digits is set to 8. If you decrease the number of PIN digits, existing PINs
will have their leading digits removed, for example, an existing user PIN of
00002134 (8 digits) will change to 02134 if the PIN digits is set to 5.
Note: This option cannot be changed if an SPC Manager PIN digit mode is set.
See SPC Manager on page 342.
Note: To comply with INCERT approvals, the user's PIN code must contain
more than 4 digits.
If enabled, both PACE and PIN are required.
261
Engineer programming via the browser
A6V10276959-d
12.09.2018