Vanderbilt SPC4 Series Installation & Configuration Manual page 288

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
Delete Delete the selected calendar.
The calendar cannot be deleted if it is currently assigned to an SPC configuration item, that is,
zone, area, user profile, output, trigger, door or X-Bus component. A message is displayed
indicating the assigned item.
Global calendars created using SPC Manager cannot be deleted.
17.10.5.1 Adding/Editing a calendar
1. Select Configuration > Calendars > Add.
The following page will be displayed:
2. Provide a Description for the calendar (max. 16 characters).
Copying a Calendar
To make a copy of this calendar structure, click the Replicate button.
A new calendar is created with the same configuration as the original calendar. You can provide a new
description for the new calendar and edit the calendar configuration as required.
Week Types
Calendars are configured by assigning an optional Week Type for each calendar week. Up to three Week
Types may be defined for each calendar. Not all weeks must have a Week Type (that is, a Week Type
may be 'None'). There is a system maximum number of 64 calendar configurations.
To configure a week type
1. Click Week Types.
2. Enter the desired times for setting/unsetting or for triggers. Use time guidelines for Automatic
Setting/Unsetting of Areas (see Automatic setting/unsetting of areas on page 290), or for Automatic
Setting/Unsetting of other Panel Operations (see Automatic setting/unsetting of other panel
operations on page 290).
Up to three week types may be configured.
© Vanderbilt 2018 288
Engineer programming via the browser
A6V10276959-d
12.09.2018