Vanderbilt SPC4 Series Installation & Configuration Manual page 206

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
****.command or **** command
where **** is the PIN and "command" is the command, that is, the PIN followed by either a space or a full
stop. For example, the command "FSET" is entered as: **** FSET or ****.FSET. The full version of the
command, where listed, can also be used. For example, ****.FULLSET.
If the user does not have sufficient rights to perform a command, the system returns ACCESS DENIED.
If Caller ID is enabled, and the sender's SMS number is configured, the PIN prefix is not required.
COMMANDS (**** = code)
Using Code
**** HELP
****.HELP
**** FSET
****.FSET
****.FULLSET
**** ASET
****.ASET
**** BSET
****.BSET
**** USET
****.USET
****.UNSET
**** SSTA
****.SSTA
****.STATUS
© Vanderbilt 2018
Using Caller
Action
ID
HELP All available commands are displayed. All available commands
FSET Sets all areas the user has access to.
FULLSET
Allows Partset A of alarm by SMS.
It is also possible to specify the
custom name defined in the
PARTSET rename field of the
Options page. See Options on
page 255.
Allows Partset B of alarm by SMS.
It is also possible to specify the
custom name defined in the
PARTSET rename field of the
Options page. See Options on
page 255.
For example:
****.ASET NIGHT
USET Unsets all areas the user has access
to.
UNSET
SSTA Retrieves the status of areas.
STATUS
206
Engineer programming via the browser
Response
Time/date of system set. If
applicable, responds with
open zones/force set zones
System set
System set
System Unset
Status of system and
applicable areas
For a single area
l
system, system and
mode are returned,
where mode is the set
status of the system.
For a multi-area system,
l
the status of each area
is returned.
A6V10276959-d
12.09.2018