Body Windows; Side Window Glass And Hinge-Swingout; Cord Installation (Typical) - Chevrolet CHEVY VAN G10 SERIES Service Manual

BODY 1B-18
Fig. 3 8 —Loosening Weatherstrip
Installation
1. A ttach leg and su pport assembly to seat. T orque to
specifications.
2. A ttach seat belts. T orque bolts to specifications.
C A U T IO N : Shoulder of bolt must b otto m on
weld nut.
3. A ttach seat to floor. T orque bolts to specifications.

BODY WINDOWS

Side Stationary Window Glass,
Weatherstrip and Reveal Moldings
Removal
1. From inside vehicle loosen w eatherstrip from flange.
N O T E : If equipped w ith reveal molding, do not
attem p t to remove moldings w hile glass is in body
opening. The moldings can only be removed after
removal of glass.
Fig. 3 9 —Cord Installation (Typical)
LO O P CORD
AT TOP
2. From inside vehicle apply pressure w ith palm o f hand to
b o tto m of glass and assist the lip o f the w eatherstrip over
the flange w ith a flat bladed tool as show n in (Figure 38).
With aid o f helper to hold w indow , continue moving
w eatherstrip over flange until w indow is o u t o f opening.
3. Remove w eatherstrip from glass, and remove reveal m o ld­
ings from w eatherstrip if so equipped.
4. Clean flange in body opening.
Installation
1. Install reveal moldings into w eatherstrip (if so equipped).
2. Install w eatherstrip o n to windshield.
3. Wrap a piece o f heavy string or cord around circum fer­
ence o f the w eatherstrip leaving a loop at the to p and the
loose ends at the b o tto m (Fig. 39).
4. Place glass in to opening. With one technician lightly
pushing in on glass, anoth er technician inside should pull
the cord as follows:
a. Pull on loose ends (Fig. 40) until each is w ithin 2 "
o f respective corner.
b. Finish seating corners by sim ultaneously pulling on
b oth ends o f the cord at each corner.

Side Window Glass and Hinge-Swingout

(Fig. 41)
Removal
1. Swing o u t window.
2. Remove screws retaining latch to body.
3. Remove w indow hinge retaining screws and window.
4. Remove latch from glass.
Installation
1
. Install latch to glass using escutcheon, spacer, washer,
latch and screw. T orque to specifications.
2. Place window into opening and install hinge retaining
screws and window.
3. Install latch to glass.
Fig. 4 0 —Pulling String to Seal Rubber Lip
------
C H E V Y V A N SH O P M A N U A L