Chevrolet CHEVY VAN G10 SERIES Service Manual page 300

FRO NT END SHEET M E T A L 11-4
NOTE Hood lock assembly
to be adjusted fore & a ft
until hood lock bolt enters
center of elongated guide.
See Section A-A. Bending
bolt to accomplish this
adjustment may seriously
effect lock operation &
safety catch engagement &
is therefore, not recommended
GUIDE'
(Part of Catch
Asm.)
SECTION A-A
Fig. 8 —Hood Lock A djustm ent
NOTE Hood bumpers must be
adjusted until hood & fender
line up to specified dimensions.
See front end sheet metal checking.
C H E V Y V A N SH O P M A N U A L