Chevrolet CHEVY VAN G10 SERIES Service Manual page 184

ENG INE FUEL 6M-10
c. Set dw ell a n d tim in g an d rec h eck low idle speed.
d. R e c o n n e c t electrical c o n n e c to r to th e solenoid.
O p e n th e th ro ttle m o m e n ta rily a n d ad ju st th e
solen o id p lu n g e r screw to th e sp ecified cu rb idle
sp eed ( R P M ) . See S pecifications, S ection
u n d e r " O th e r A d ju stm e n ts" .
ACCELERATOR AND CHOKE
CONTROLS
TH R O TTLE LINKAG E (Fig. K5 thru K7)
The th ro ttle control system is o f th e cable typ e. There are
no th ro ttle linkage adjustm ents, a reference betw een the
b o tto m o f the accelerator pedal roller and floor pan should be
used only as a check for b en t b racket assemblies. Check torque
references in Figures K5 th ru K 7. Check for correct opening
and closing positions b y operating accelerator pedal in car.
Cable routing attach m en t, carburetor positioning for proper
assembly should be n o te d in 1972 as depicted by some o f the
follow ing illustrations.
N O T E : If any binding is present, check fo r correct
routing of cable or pedal interference w ith carpets.
TH R O TTLE ROD KICKDOWN
LINKAG E ADJUSTMENT
1. D isconnect th ro ttle
carburetor or at dash lever.
N O T E : Cable controls do not require adjustment.
2. On autom atic transm ission equipped vehicles disconnect
TV rod at th ro ttle lever.
rod swivel at th ro ttle lever on
Fig. K 6—Accelerator Linkage— L 6 Engine
3. H old carburetor thro ttle in wide open position, push
th ro ttle rod rearw ard (to position accelerator pedal at the
floor m at) and adjust swivel to ju st enter hole in th rottle
lever.
6 4. Connect swivel to th ro ttle lever and install accelerator
M ,
return spring.
5. O n vehicles equipped w ith autom atic transm ission hold
th ro ttle lever in full open position, pull TV rod to full
d eten t position and adjust TV rod to ju st enter hole on
th ro ttle lever, and connect TV rod at th ro ttle lever.
C H E V Y V A N SH O P M A N U A L