Chevrolet CHEVY VAN G10 SERIES Service Manual page 317

DRIVE PLATE A N D SHAFT ASSEMBLY
PARTIALLY DISASSEMBLED FR O M
G E A R A N D TUBE ASSEMBLY
IN N E R SPACER
W A S H E R
Fig. 2 4 —Drive Gear Removal
C A U T IO N : Be sure tabs are centered in brush
plate mtg. holes.
C A S T IN G
G R O M M E T
STAKE M A R K S -
CASE T O FIELD
LA M IN A (4 PLACES)
Fig. 2 5 —W iper M o tor Separation
DRIVE PLATE SUPPORTS
W H E N ASSEMBLED
PROPERLY , DRIVE
PLATE S H O U L D FIT
TIGHTLY BETW EEN
THE SUPPORTS
7. Remove brush retainer clips and resolder black cotton
8. If new case and field assembly is used, scribe a line on it
M O T O R
LEADS
E L E C T R IC A L -B O D Y A N D CHASSIS 12-17
CUT
GENERAL AREA FOR SPLICING
BRUSH PLATE ASSEMBLY
RETAINER TAB
BLACK
CIRCUIT BREAKER
CIRCUIT
BREAKER
Fig. 2 6 —C ircuit Breaker
covered lead to circuit breaker. Refer to Figure 26.
in the same location as the one scribed on the old case.
Fig. 2 7 —Removing Brush Holder
RETAINER CLIP
1-S O L ID BLACK TO
SHUNT FIELD COIL
2-SERIES FIELD COIL
TO BLACK W ITH PINK
STRIPE LEAD
C H E V Y V A N SHOP M A N U A L