Chevrolet CHEVY VAN G10 SERIES Service Manual page 330

RADIO REPLACEMENT (Fig. 1)
1. D isconnect ground cable from battery.
2. Remove engine cover.
3. Remove air cleaner on carburetor.
Remove stud in carburetor throat for m ounting air
4 .
cleaner.
5. Cover carbureto r th ro at w ith clean plastic to prevent dirt
or radio attachm ents from falling into carburetor.
6
. Remove knobs, washers and nuts from control shafts on
fro n t of radio.
7. Remove bracket from rear side o f radio entirely.
8
. Now guide radio back and up through engine access area,
SECTION 15
ACCESSORIES
gently tilt radio dow n and slide radio out far enough to
disconnect electrical connectors and aerial.
9. Reverse removal procedure for installation o f radio.
SPEAKER REPLACEMENT
1. Follow radio removal steps 1 through
2. Remove left heater d u ct attached to engine cover ex­
tension by (
3. Remove (1) speaker m ounting screw and low er speaker
out engine cover opening.
4. Reverse steps 1, 2 and 3 above for speaker replacem ent.
Fig. 1 —Radio and Speaker Mounting
8
.
1
) screw.
C H E V Y V A N SHOP M A N U A L