Chevrolet CHEVY VAN G10 SERIES Service Manual page 273

10. Press the steering shaft upper bearing o u t o f the switch
co n tact support.
11. Remove the shift lever housing seat and bushing from the
upper end o f the colum n.
12. Remove the bolt and screws from the adjusting ring
clam p and remove the clam p, adjusting ring and lower
bearing. Press the lower bearing o u t o f th e adjusting ring.
13. 3-Speed Columns— Remove 1 st-reverse shift lever and
lever spacer.
Automatic Columns—Remove the selector plate clamping
ring screws.
14. Place the colum n upright on the floor, supporting it w ith
tw o pieces o f w ood. Place a block o f w ood on the upper
end o f the shift tu b e. Press dow n on th e shift lever w ith
fo o t while tapping on the w ood block to w ithdraw the
tube from the colum n jacket.
C A U T IO N : In some tolerance stack-up cases it may
be necessary to use a press. Be careful not to damage
the tube or jacket.
15. Remove the felt seal from th e shift tube.
16. Remove the toe pan seal from the colum n jacket.
1. Steering Shaft N u t
2. Flat Washer
3 . T u rn Signal Cancelling Cam
4. Turn Signal Switch Screw
5. T u rn Signal Switch
6 . Steering Shaft Upper Bearing
7. Switch Contact Support
8. Turn Signal Housing
9 . Turn Signal Switch Lever Screw
10. T u rn Signal Switch Lever
11. Rubber Ring
12. Plastic Thrust Washer
13. S h ift Lever Housing
14. S h ift Lever Pin
15. S h ift Lever
16. Steering Shaft
Fig. 12 — Steering Colum n (3-Speed M anual) — Explode
INSTRUMENT PANEL HARNESS
PLUG INTO
CLUSTER FEED CAVITY
OF FUSE PANEL ( j j
Fig. 11 — T ilt C olum n S hift Indicator Light
Assembly
N O T E : In the follow ing assembly sequence, use a
general purpose lithium soap grease fo r lubricating
those components so indicated.
17. S h ift Lever Housing Bushing
18. Bushing Seat
19. Steering Column Jacket
20. To e Pan Seal
21. Adjusting Ring Clamp
22. Adjusting Ring Clamp Screws
23. Adjusting Ring Clamp Bolt
STEERING 9-7
PEDAL
SUPPORT BRKT
COLUMN
24. N u t and Lockwasher
25. S hift Tube Assembly
26. S hift Lever Spacer
27. 1st-Reverse S h ift Lever
28. Adjusting Ring
29. Shaft Lower Bearing
3 0 . Lower Bearing Preload Spring
3 1 . Preload Spring Clamp
C H E V Y V A N SH O P M A N U A L