Instrument Panel; Cowl Ventilator Grille; Inside Rear View Mirror; Engine Access Cover - Chevrolet CHEVY VAN G10 SERIES Service Manual

BODY 1B-6
Installation
1. Install insert into trim panel.
2. Install panel and insert in to the in strum ent panel and
install retaining nuts.

Instrument Panel

Removal
1. Rem ove Steering C olum n, and all Instrum ents as outlined
in Sections 9, 12, 15.
2. Rem ove bolts securing panel assembly to dash.
Installation
1. Reverse above procedure. T orque bolts to specifications.
Cowl Ventilator Grille (Fig. 11).
Removal
1. Remove w indshield w iper blades.
2. Remove screws retaining grille and remove grille and seal.
Installation
1. Install grille and seal.
2. Install wiper blades. Check sweep o f blades and adjust as
„ necessary.
Inside Rear View Mirror (Fig. 12)
Removal
1. Remove screw retaining m irror to its glass-mounted
b racket and remove m irror.
Installation
1. Install m irror into its m ounting bracket. T orque screw to
specifications.
Sunshade
Removal
1. Remove sunshades to header panel screw.
Installation
1. Install sunshade to header panel screw and to rq u e to
specifications.

Engine Access Cover

Removal
1. U nlatch cover from cowl.
2. Remove holddow n bolts securing cover to floor (at rear
side).
3. C arefully slide rearw ard, lifting rear o f cover to clear
instrum ent panel.
Installation
1. Reverse steps 1 , 2 , 3 above.
FRONT SIDE DOOR
Door Hinge
Remove
1. Remove hinge access hole cover from door hinge pillar.
2. If removing one hinge, support door in such a m anner
th a t weight is taken o ff oth er hinge, and also, support in
such a m anner th a t door will n o t move.
3. Remove hinge screws from b o th body and from door and
remove hinge.
Installation
1. Install hinge to d o o r and body. Snug bolts.
2. Remove door supports.
3. A djust door as o utlined u n d er " D oor A djustm ent" .
4. Torque bolts to specifications.
5. Install hinge access hole covers.
C H E V Y V A N S H O P M A N U A L