Series 30 5200 Capacity Axle; Axle Assembly - Chevrolet CHEVY VAN G10 SERIES Service Manual

REAR SUSPENSION A N D D R IV E L IN E 4-10
1. Universal Joint Y oke
2. Pinion Bearing and Oil Seal Retainer
3. Oil Seal
4. Gasket
5. Fro n t Pinion Bearing
SERIES 30 5200 CAPACITY AXLE (FIG. 17)

Axle Assembly

Service operations on these axle assemblies m ay be per­
form ed w ith the housing installed in the vehicle or w ith the
Fig. 1 7 —Rear A xle Cross Section (Series 30, 5 2 0 0 lb.)
11.
6. Drive Pinion
Pinion Bearing Shim 12.
7.
Rear Pinion Bearing 13.
8.
14.
Ring Gear Thrust Pad
9.
10. Ring Gear 15.
Differential Spider
Differential Pinion (Spider) Gear 17.
D ifferential Side Gear
D ifferential Case—L e ft Half
Axle Shaft
housing installed in a holding fixture. There m ay be occasions
however, w hen it will be necessary to remove the com plete
housing assembly. The following axle assembly removal and
installation procedure, therefore, is necessary only when
housing replacem ent is required.
D ifferential Bearing
16.
D ifferential Bearing Adjusting N ut
18. Adjusting N u t Lock
19. Differential Case—Right H alf
C H E V Y V A N S H O P M A N U A L