Rear Mount Replacement - Chevrolet CHEVY VAN G10 SERIES Service Manual

b. Rem ove th e tw o bolts securing clutch cross shaft
b rack et to fram e side rail, and position clutch
linkage away from engine m o unt.
3. Rem ove m ount-to-bracket through-bolt.
4. Raise engine sufficiently to clear m o unt. Remove bolts
securing m o u nt to frame bracket.
5. Install new m ou nt to fram e bracket, and torque bolts to
specifications.
6
. L ow er engine to align m o unt w ith engine bracket. Install
through b olt and to rq u e to specifications.
7. On m anual transm ission equipped vehicles.
a. Position clutch cross shaft betw een frame side rail
and ball stud on engine bracket. Install and torque
fram e bolts.
b. C onnect clutch ro d at o u tboard lever on clutch
cross shaft.
8
. Low er vehicle on hoist an d check operation o f clutch.
Rear Mount Replacement (Fig. 26L)
1. Raise vehicle on hoist and support transm ission so as n o t
to interfere w ith support crossm em ber removal.
2. Remove bolts securing rear m ount to sup po rt cross­
mem ber.
3. Remove support crossm em ber retaining bolts from
underbody cross rail an d w ithdraw sup po rt from vehicle.
4. Remove bolts securing m o u n t to transm ission extension.
5. Install new rear m o u n t and torque bolts to specifications.
6
. Position support crossm em ber to cross rail, install bolts
th en loosely install crossm em ber-to-m ount retaining
bolts.
7. Remove sup po rt from rear o f transm ission, torqu e re­
m aining bolts to specifications and lower vehicle on
hoist.
ENGINE 6-25
C H E V Y V A N SH O P M A N U A L