Chevrolet CHEVY VAN G10 SERIES Service Manual page 179

Fig. 11C —C hoke U n lo a d e r (2 G V )
2GV (Fig. 13C)
1. H old choke valve com pletely open.
2. With the therm ostatic coil rod disconnected from upper
lever, push dow nw ard on rod to end o f travel.
3. With the rod in the fully dow nw ard position, b o tto m o f
rod should be even w ith the b o tto m o f slotted hole in
lever as shown.
Fig. 12 C —Choke Coil Rod Adjustm ent (M V )
Fig. 1 3 C —C hoke C oil R od A d ju s tm e n t (2 G V )
4. To adjust, bend lever at point shown w ith screwdriver
end.
4M V (Fig. 14C)
1. H old choke valve com pletely closed by rotating choke
coil lever counterclockw ise.
2. W ith the therm ostatic coil rod disconnected, w ith cover
rem oved, push dow nw ard on coil rod so th a t the rod
contacts bracket surface.
3. The coil ro d m ust fit in choke lever n o tch , as shown.
4. Bend choke coil rod at p o in t show n to adjust.
5. Install choke coil spring cover.
6
. Insert coil rod in to choke coil lever slot and install
retaining clip.
7. Make sure that the choke valve operates freely from the
full open to full closed position.
RO TA TE C O IL LEV ER /
CO U N TER CLO C K W ISE
U N TIL C H O K E V A LV E
IS C LO SED
—^ ROD
IN NOTCH IN LEVER
Fig. 14C —Choke Coil Rod Adjustm ent (4 M V )
ENGINE FUEL 6M-5
CH O KE V A LV E
C O M P LETELY
C LO SED !
HOLD ROD AGAINST
BRACKET SURFACE
CHOKE COIL ROD
ADJUSTMENT
C H E V Y V A N SHOP M A N U A L