Rear L I G H Ti N G; Marker Lamps; Wiper-Washer Switch Replacement - Chevrolet CHEVY VAN G10 SERIES Service Manual

PARKING LAMP HOUSING REPLACEMENT
(Fig. 3)
N O T E : T h e lam p housing and lens are not inter­
changeable left to right side.
Left Side
1. O pen hood for access.
2. D isconnect lead.
3. Rem ove (2 ) tw o n u t assemblies from rear o f parking lamp
housing.
4. F rom fro n t o f grille wiggle lamp assembly o u t grille
opening.
5. Install new lamp assem bly in reverse order o f removal.
Right Side
1. Rem ove headlam p bezel and headlam p.
2. R each through headlam p opening for access to parking
lam p lead connector.
3. Reaching through headlam p opening, remove (2) tw o n u t
assemblies retaining lamp housing.
F rom fro n t o f grille tilt and slide parking lamp housing
4.
from grille opening.
5. Install new lamp assembly in reverse order o f removal.
REAR L IG H TIN G (Fig. 4)
The bulbs m ay be replaced by removing the lamp lens
attaching screws and lam p lens. The lamp housings m ay be
replaced b y removing th e lam p housing attaching nuts.
ELE C TR IC A L - BODY A N D CHASSIS 12-3
Fig. 4-R ea r Lighting

MARKER LAMPS

Front Bulb
1. O pen hood.
2. G rasp plug co nnector and rotate 1/4 tu rn counter-clock­
wise to remove bulb inset in plug connector.
3. Install new bulb, check operation and clcse hood.
Rear Bulb
Same procedure as fro n t bulb except w ith rear bo dy inside
trim .
1. Remove (2 ) screws retaining rear m arker lam p housing to
body.
2. Reach behind lam p housing and ro tate connector plug
1/4 tu rn to remove bulb inset in plug connector. Do not
pull ground lead loose.
3. Install new bulb, check op eration o f bulb and install rear
m arker lam p housing in b o d y side.

WIPER-WASHER SWITCH REPLACEMENT

(Fig. 5)
1. D isconnect b attery ground cable.
2. Reach up behind left side o f instrument panel, standing
outside vehicle and:
A. Remove plug con necto r from rear o f switch.
B. Remove (3) m ounting screws securing bezel and
ground wires to switch.
3. Replace switch, installing ground wire and connector.
Check operation o f sw itch, first observing if washer
solvent is in engine co m partm ent container.
C H E V Y V A N S H O P M A N U A L