Chevrolet CHEVY VAN G10 SERIES Service Manual page 240

CLUTCHES & TRANSM ISSIONS 7-2
CLUTCH LEVER
CLUTCH CONTROL RODS
and not the usable stroke, the lash m ust be reduced to
specifications in order to gain the additional stroke benefit.
CLUTCH PEDAL REPLACEMENT
(Refer to Fig. 1)
Removal
1. Pull parking brake lever to applied position.
2. Remove b o lt at clutch pedal push rod lever, then remove
lever from pedal shaft.
3. Hold pedal pad w ith one hand and slide pedal and shaft
assembly o utboard enough to clear pedal sto p , then allow
retu rn spring (or overcenter spring) to pull pedal up high
enough to unhook spring from pedal arm.
4. Remove pedal and shaft assembly from support bracket.
Inspection
1. Check clutch pedal bushings for excessive wear and
replace if necessary.
2. C heck clutch pedal shaft for wear and alignm ent and
straighten or replace if necessary.
CLUTCH PEDAL
ASSEMBLY
GE 20-30
Fig. 1—Clutch Pedal and Linkage Assemblies
Installation
N O T E :
cate w ith Lubriplate or petrolatum .
BRAKE PEDAL
BRKT. ASM
CLUTCH PEDAL
ASSEMBLY
GA 10 GS 20-30
CLUTCH SHAFT
& BRACKET
Use new shaft bushing if needed and lubri­
C H E V Y V A N SH O P M A N U A L