Outside Rear View M Irrors; Instrument Panel Compartment - Chevrolet 30 Series 1967 Service Manual

BODY IB-22
Fig. 48 - Side W ind o w - Sw ing-O ut
"wiper" on dash. Wiper motor service operations are
outlined in Section 12.
Arm Adjustment
To adjust sweep of blades, turn on wipers and note
sweep of arms\ If necessary, remove one or both arms
as follows: Pull outer end of arm away from glass which
will trip lock spring at base of arm and release spring
from undercut of pivot shaft. While holding arm in this
position, pull outward on cap section at base of arm to
remove arm. Align serrations on pivot shaft and in arm
cap with arm in position to obtain satisfactory sweep and
press cap onto shaft.
WINDSHIELD WIPER TRANSMISSIONS
AND LINKAGE
Removal (Right and Left Side)
CAUTION:
As a safety precaution, disconnect
battery ground cable before working under in­
strument panel.
Fig. 49 - Heater Duct and Distributor Removal
1. Remove windshield wiper arms from pivot shafts.
A tool is available for removing the arms. See
above procedure for "Arm Adjustment".
2. Remove radio, if so equipped.
3. Remove the heater distributor and duct outlet as­
semblies (fig. 49) as outlined in Section 13.
4. Remove the two nuts attaching the short link to the
motor under dash.
5. Disconnect two screws securing each of the two
(right and left side) pivot shafts.
. Disengage the pivot shafts, gaskets and linkage and
6
remove the vehicle (fig. 50).
Installation
1. Connect the transmission and linkage assembly as a
unit and install with screws under dash with gaskets
in place.
2. Connect the short link to the motor and install the
nuts.
3. Install the radio.
4. Install the heater distributor and duct outlet assem­
blies as outlined in Section 1A.
5. Before installing wiper arm s, connect the battery
and operate wiper motor momentarily which should
rotate pivot shafts to park position. Install arms and
shafts so they are located in the park position. Again
operate wipers and check wiper sweep pattern. Re­
position arms on pivot shafts if necessary.
OUTSIDE REAR VIEW MIRROR
The standard rear view m irror assembly is mounted to
the door and retained by a lock washer and acorn nut.
The bracket assembly is secured with three screws. A
pad is located between the bracket and the door. The
deluxe m irror bracket is mounted with 2 screws. An in­
board set screw fastens the m irror assembly to the
bracket.

INSTRUMENT PANEL COMPARTMENT

Glove Box (Fig. 51)
Removal
1. Remove three screws retaining the compartment
door hinge assembly to the compartment
2. Unhook the check rod and remove door assembly.
3. Remove three screws from the upper surface near
the front of the compartment and the three screws
located under the lower surface near the front of the
compartment.
4. Disengage the compartment by sliding rearward and
out.
Fig. 50 - Windshield W iper Linkage Removal (T y p ica l)
CHEVROLET TRUCK SERVICE MANUAL