Show The Ip Routing Table - Digi TransPort WR11 User Manual

Managing networks and connections

Show the IP routing table

É
Web
Go to Management > Network Status > IP Routing Table.
The IP Routing Table page displays the IPv4 routing table.
Destination
The destination IP network of the route. To use the route, the destination must match the destination
IP address of an IP packet. For default routes, the destination IP network is always 0.0.0.0/0. The
router uses default routes when no other route matches the destination IP address of an IP packet.
Src Addr
When source address routing in use, to use the route, the Src Addr value must match the source IP
address of an IP packet.
Gateway
The IP address of the next router to which the IP packet will be routed to reach the destination
network. On PPP and TUN interfaces, and ETH interfaces that have the gateway configured, this
parameter can be blank.
Metric
The route metric defines the cost of the route. If CIDR routing is enabled and there are two routes to
the same destination, the router uses the route with the lower metric.
Protocol
The protocol that created the route. This setting can be one of the following:
Setting Description
Local The route is for a network connected directly to the router.
Remote The route is for a remote network accessed via a PPP connection.
Static The route is a static route.
Static/RIP The route is a static route that has been updated by RIP.
RIP The route is a RIP route.
Digi TransPort® Routers User Guide
Show network interface status
856