Digi TransPort WR11 User Manual page 172

Using the command-line interface
sent.
at\smib=mib-2.interfaces.iftable.ifentry.ifouterrors: Show number of outbound packets
containing errors
Shows the number of outbound packets that this interface could not transmit because of errors.
Commands for displaying IP node information
The IP node consists of the ipforwarding variable and the ipaddrtable and iproutetable nodes.
at\smib=mib-2.ip.ipforwarding: Show whether router is an IP gateway
Indicates whether the router is acting as an IP gateway in respect to the forwarding of datagrams
received by, but not addressed to, the router. IP gateways forward datagrams, IP hosts do not. For
the router, this value is always 1.
at\smib=mib-2.ip.ipaddrtable: Show IP address table
Shows the IP address table. The ipaddrtable node contains ipaddrentry nodes for each IP address
assigned to each interface of the router. For each table entry, an index specifier must be appended to
the end of each variable that specifies the interface (such as for PPP0, 1 must be appended).
at\smib=mib-2.ip.ipaddrtable.ipaddrentry
at\smib=mib-2.ip.ipaddrtable.ipaddrentry.ipadentaddr: Show IP address
Shows the IP address to which this entry's addressing information pertains.
at\smib=mib-2.ip.ipaddrtable.ipaddrentry.ipadentifindex: Show index number for an
IP address
Shows the index identifier for the interface associated with this IP address.
at\smib=mib-2.ip.ipaddrtable.ipaddrentry.ipadentnetmask: Show the subnet mask for an
IP address
Shows the subnet mask associated with the IP address.
at\smib=mib-2.ip.ipaddrtable.ipaddrentry.ipadentbcastaddr: Show IP broadcast address
Shows the value of the least-significant bit in the IP broadcast address for sending datagrams on the
IP address of this interface.
at\smib=mib-2.ip.iproutetable: Show IP route table
Shows the IP route table. The iproutetable node contains iprouteentry nodes for each route defined
on the router.
at\smib=mib-2.ip.iproutetable.iprouteentry
at\smib=mib-2.ip.iproutetable.iprouteentry.iproutedest: Show the destination IP address for
the route
Shows the destination IP address for the route. An entry with a value of 0.0.0.0 is considered the
default route. Multiple routes to a single destination can appear in the routing table, but access to
such multiple entries is dependent on the table-access mechanisms defined by the network
management protocol in use.
Digi TransPort® Routers User Guide
AT commands
172