Digi TransPort WR11 User Manual page 635

Configuring legacy protocols
Disconnect the layer 2 call if there is no layer 3 call in progress for x seconds
The length of time, in seconds, after which the router disconnects a layer 2 link if there are no
layer 3 calls in progress. For LAPB sessions, this also terminates the ISDN call.
Create an event when the following data is on the PAD
A string, which if it appears in the received data causes a Data Trigger (47) event to be
generated and recorded in the event log.
Create an event when there has been no activity on the PAD for x seconds
The time, in seconds, in which if there is no activity on the PAD an event in the event log is
posted. You can use this parameter to trigger email exceptions.
5. Click Apply.
Command line
Command Instance Parameter Values
pad n
pad n
pad n
pad n
pad n
pad n
pad n
pad n
pad n
pad n
pad n
pad n
pad n
pad n
Digi TransPort® Routers User Guide
l2iface lapb, lapd, TCP, SSL
l2nb 0-255 (instance of
LAPB or LAPD)
ip_stream 0=off (for XoT),
1=TCP, 2=UDP
defpak 16,32,64,128,256,512
or 1024
ansnua text (valid NUA)
anscug text (valid CUG)
amacro text
cingnua text (valid NUA)
lcn 1-4095
lcnup 1=up, 0=down
nuaimode 0=NUI and NUA,
1=NUA only, 2=NUI
only
dorest 1=enabled,
0=disabled
restdel 0 -60000 (ms)
IPaddr text
Configure X.25 parameters
Equivalent web parameter
Use PAD over interface
Use PAD over interface
Use PAD over interface
Default X.25 packet size
Answer incoming calls from NUA
Only answer calls with CUG
Use X.25 Call Macro macroname to an
ATD command
Use NUA
LCN
LCN Direction
NUI/NUA selection
Enable X.25 Restart Packets
Restart delay
Remote IP address
635