Digi TransPort WR11 User Manual page 243

Configuring network interfaces
Concatenate replies
Normally an SMS message is limited to 160 characters. However, the ETSI standard specifies a
way to allow a number of SMS messages to be linked together by the sender (in this case the
router). This enables the router to reply with long responses to SMS commands of longer than
160 characters. The reply comes back as a series of linked SMS messages which the phone
reassembles and displays as one big message.
Note The routers cannot handle received concatenated SMS messages, it can only transmit
concatenated SMS messages
Use this SMS message centre number n instead of the network default
This setting is optional. It is the number of the SMS message center (sometimes referred to as
the Service Centre Address), for relaying SMS messages or alarms. This number must include
the international dialing code, such as 44 for the UK, but not the + prefix or leading zeros, such
as 44802000332. SMS alarms are generated when the SMS trigger priority is greater than 0
and an event of this priority or higher occurs. SMS alarms may be configured using the
Configuration > Alarms > Event Settings > SMS web page. If no number is specified, it is
possible that the router operates using the default message centre for the GSM service to
which you have subscribed.
SMS access level
The access level for SMS commands. The access level set here needs to match the level
required by the command sent by SMS for the command to be accepted.
Use x as a command separator (default is CR)
The character for separating multiple command lines when a remote SMS sender is controlling
the router. The default separator is <CR>. As some SMS capable devices are not equipped with
<CR> keys, an additional means of separating multiple lines is required.
Allow CLI commands from the following SMS numbers.
You can specify up to 10 numbers. Specifying * permits commands from any SMS number.
Numbers are applied in the following input box. Click Add to submit.
Command line
Commands-for SIM Slot 1 (PPP 1)
Command Instance Parameter
modemcc 0
modemcc 0
modemcc 0
Digi TransPort® Routers User Guide
Values
sms_
interval
sms_ on/off
replies
sms_ Number
concat 0=off
10=default
when enabled
Configure mobile (cellular) interfaces
Equivalent web parameter
Poll for incoming SMS messages:-
Every n minutes
Enable command replies via SMS
Concatenate replies
243