Digi TransPort WR11 User Manual page 636

Configuring legacy protocols
Command Instance Parameter Values
pad n
pad n
pad n
pad n
pad n
pad n
pad n
pad n
pad n
pad n
pad n
pad n
pad n
pad n
pad n
pad n
Stopping and starting PADs
To stop and start PAD instances, use the following CLI commands:
stoppads: Stops all PAD instances from accepting and performing any PAD commands.
n
gopads: Resumes processing of PAD commands.
n
The stoppads and gopads commands can have the PAD number specified in the syntax to stop and
start individual PAD instances.
For example:
Digi TransPort® Routers User Guide
buipaddr text
ip_port 0-65535
iphdr 0=Off
1=On
2=8583 Ascii 4 byte
prompt text
padmode 0=Normal
1=Prompt Always On
profile 1-4, 50, 51,90,91
strip_ 1=enabled
0=disabled
tspaces
llmode 1=enabled
0=disabled
enqcon 1=enabled
0=disabled
stxmode 1=enabled
0=disabled
delconmsg 0-10
data_del 0-2147483647
inacttim 0-1000
nocalltim 0-60000
trig_str text
inactevent 0-2147483647
Configure X.25 parameters
Equivalent web parameter
Remote IP Address when using the
backup interface
IP Stream port
IP length header
PAD prompt
PAD mode
Use PAD Profile
Strip Trailing Spaces
Enable Leased Line Mode
Send ENQ on Connect
Enable STX / ETX Filtering
Delay connect message n x 10
milliseconds
Delay data transfer after connection by
n x 10 milliseconds
Terminate the PAD call after x seconds
if there has been no data transmission
Disconnect the layer 2 call if there is no
layer 3 call in progress for x seconds
Create an event when the following
data is on the PAD
Create an event when there has been
no activity on the PAD for x seconds
636