Digi TransPort WR11 User Manual page 446

Configuring IP routing and forwarding
Command Instance Parameter Values
def_route n
def_route n
def_route n
def_route n
def_route n
def_route n
def_route n
def_route n
def_route n
def_route n
def_route n
def_route n
def_route n
Digi TransPort® Routers User Guide
inact2add 0-
2147483647
pwr_dly 0-255
actooslim 0-
2147483647
chkoos_int 0-
2147483647
chkoos_ 0-
deact 2147483647
dial_int 0-255
Default 10
q1 on,off
deact_ent Blank,PPP
deact_add 0-
2147483647
deact_ Blank,PPP
ent2
deact_ 0-
add2 2147483647
unoos_ 0-
secs 2147483647
rgroup 0-255
Configure default IP routes
Equivalent web parameter
Make PPP n interface use the alternative idle
timeout when this route becomes available
Wait for s seconds after power up before
allowing this route to activate the interface
Mark this route as "Out Of Service" if the
interface fails to connect after n consecutive
attempts
If the interface fails to connect, try again in s
seconds
Deactivate the interface after it successfully
connects
Do not allow this interface to be activated by this
route for s seconds after the last activation
attempt
Only queue one packet whilst waiting for the
interface to connect
When this route becomes available, deactivate
the following interfaces x,y
When this route becomes available, deactivate
the following interfaces x,y
When this route becomes available, deactivate
the following interfaces x,y
When this route becomes available, deactivate
the following interfaces x,y
Keep this route in service for s seconds after
OOS state is cleared
Assign this route to recovery group n
446