Digi TransPort WR11 User Manual page 608

Configuring legacy protocols
Generate an event when a TPAD transaction takes longer than x seconds
Setting this parameter to a non-zero value causes the router to generate an
Excessive Transaction Time event (code 56) each time a TPAD transaction takes longer that
the specified number of seconds. You can use this setting with an appropriate Event Handler
configuration to generate email alert messages or SNMP traps when TPAD transactions take
longer than expected. See Configuration > Alarms > Event Logcodes for a complete list of
events.
When the transaction time exceeds x milliseconds, increment the "SLA
Exceptions" statistic
When the total transaction time exceeds the value (in ms) set in this parameter, the NB SLA
exceptions statistic on the Diagnostics - Statistics > TPAD page is incremented. This statistic
can be viewed on the CLI interface by entering the at\mibs=tpad.n.stats command, where n is
the TPAD instance.
Clear the call x seconds after receiving a response
The time period for which the socket closing or the X.25 call clearing is delayed by after the
TPAD session has finished. For example, if this parameter is set to 10, then 10 seconds after
the TPAD session is finished (NO CARRIER is seen on the ASY TPAD port) the network call (X25
or TCP socket) is cleared. The number 1 is a special value. If set to the number 1, the call is
cleared immediately, instead of after 1 second.
If the terminal dial command specifies V.120 use PANS context x
This parameter is for advanced users only. It enables TPAD transactions to be carried out using
the V.120 protocol (ATDV command). Use this parameter with the Polling Answering Service
(PANS). It identifies which PANS instance to use for an outgoing V.120 call. For this to work, the
PANS instance must be bound to a Rate Adaption instance.
5. Click Apply.
Command line
Command
tpad
tpad
tpad
tpad
tpad
tpad
tpad
Digi TransPort® Routers User Guide
Instance Parameter
n l2iface
n l2nb
n ipmode
n bakl2iface
n bakl2nb
n bnumber
n prefix
Values
lapb, lapd, tcp, ssl, vxn
0-255
lapb, lapd, tcp, ssl, vxn
0-255
text (valid ISDN number)
text (numeric)
Configure TPAD parameters
Equivalent web
parameter
Use TPAD over interface.
Use TPAD over interface.
Use TPAD over interface.
Use backup interface.
Use backup interface.
Use number x to make
outgoing ISDN calls.
Use prefix x
608