Digi TransPort WR11 User Manual page 888

Managing networks and connections
tilde (~) symbol before the list of protocol numbers. For example, to only capture UDP traffic,
enter ~17 for this parameter.
IP Addresses
Filters out IP packets with particular source or destination IP addresses. The format of this
parameter is a comma-separated list of IP addresses. For example, you may want to exclude
the capture of traffic from IP hosts 10.1.2.3 and 10.2.2.2. To do this, enter 10.1.2.3,10.2.2.2
for this parameter. Conversely, to capture traffic to and from particular IP hosts only, use a
tilde (~) symbol before the list of IP addresses. For example, to only capture packets to and
from IP host 192.168.47.1, enter ~192.168.47.1 for this parameter.
3. Click Apply.
Command line
Command Instance Parameter
ana 0
ana 0
ana 0
ana 0
ana 0
ana 0
ana 0
ana 0
ana 0
ana 0
ana 0
ana 0
ana 0
ana 0
ana 0
ana 0
ana 0
Digi TransPort® Routers User Guide
Values
anon on, off
maxdata 16-2000
logsize 3 -180
l1on on, off
l2on on, off
l3on on, off
xoton on, off
ikeon on, off
qmion on, off
snaipon on, off
lapdon 0-7
See below
lapbon 0-7
See below
asyon Bitmap
See below
syon Bitmap
See below
discardson on, off
loopon on, off
ipfilt Comma-separated
list
Analyze data traffic
Equivalent web parameter
Enable Analyser
Maximum packet capture size
Log Size
Protocol Layers / Layer 1
Protocol Layers / Layer 2
Protocol Layers / Layer 3
Protocol Layers / XOT
Enable IKE debug
Enable QMI trace
Enable SNAIP trace
ISDN Sources
LAPB Links
Serial Interfaces
Raw SYNC Sources
IP Options / Trace discarded packets
IP Options / Trace loopback packets
IP Packet Filters / TCP/UDP Ports
888