Configure Access Lists - Digi TransPort WR11 User Manual

Configuring IP routing and forwarding
Command line
Command Instance Parameter
rip n
rip n
rip n
rip n
rip n
rip n

Configure access lists

The router can modify route metrics based upon received RIP responses. Static routes and default
routes have their metric modified if the route fits within one of the routes found within the RIP
packet. For Ethernet routes, the gateway for the route will be set to the source address of the RIP
packet. The route modifications will be enforced for 180 seconds, unless another RIP response is
received within that time.
RIP packets must have a source address that is included in the RIP access list.
Adding permitted IP addresses to the access list is controlled using a table with the single parameter
described below.
É
Web
Go to Configuration > Network > IP Routing/Forwarding > RIP > Global RIP Settings > Access
Lists.
IP Address a.b.c.d
The IP address to be added to the list of IP addresses that RIP packets must come from if they are to
modify route metrics. Up to ten IP addresses may be added. The Add and Delete buttons work in the
usual way for configuration tables.
Digi TransPort® Routers User Guide
Values
enable on,off
interval 0-
2147483647
ripto 0-
2147483647
riplingerto 0-
2147483647
updatestatic on,off
poisonreverse on,off
Configure Routing Information Protocol (RIP) settings
Equivalent web parameter
Enable RIP
Send RIP advertisement every s seconds
Mark routes as unusable if we don't get
advertisement for s seconds
Delete routes after another s seconds
Allow RIP to update static routes
Enable Poison Reverse
448