Digi TransPort WR11 User Manual page 229

Hide thumbs Also See for TransPort WR11:
Table of Contents

Advertisement

Configuring network interfaces
Configure mobile network settings
Command
Instance
ppp
1
ppp
1
ppp
1
ppp
1
ppp
1
ppp
1
ppp
1
Automatic APN selection
Certain variants of Digi TransPort routers include support for automatically selecting an Access Point
Name (APN). This functionality is only available for routers with the following cellular module types:
SIERRA_LTE
n
TELIT_LTE
n
TELIT_LTE_V2
n
To determine the APN, the router uses an IMSI to APN assignments file, imsi.txt. The imsi.txt file
maps ICCID and IMSI prefixes to APN values. For more information about updating and editing the
imsi.txt file, see imsi.txt.
Getting Started Wizard
Automatic APN selection is initially configured in the Getting Started Wizard on the Cellular
connectivity page, by using the Allow automatic APN detection? option. If the router detects a
supported cellular module and can determine the APN, this option will default to Yes. This will set the
APN name to None, which allows the router to automatically detect the name.
Web UI
The Mobile Settings page of the Web UI (Configuration > Network > Interfaces > Mobile > Mobile
Settings) includes the Select APN automatically checkbox. This checkbox is automatically enabled if
APN detection was enabled in the Getting Started Wizard.
If automatic APN selection is enabled in either the Getting Started Wizard or the Web UI, but the
router cannot determine the APN, the APN will be set to None.
Digi TransPort® Routers User Guide
Parameter
Values
do_nat
1
do_nat
2
ipsec
1
ipsec
2
ipsecent
blank,ETH,PPP
ipsecadd
0-255
firewall
off, on
Configure mobile (cellular) interfaces
Equivalent web parameter
Enable NAT on this interface
IP Address
Enable NAT on this interface
IP Address and Port
Enable IPsec on this interface
Keep Security Associations (SAs)
when this Mobile interface is
disconnected
Use interface X, Y for the source IP
address of IPsec packets
x=Interface type
Use interface X, Y for the source IP
address of IPsec packets
y=interface number
Enable the firewall on this interface
229

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents