Digi TransPort WR11 User Manual page 610

Configuring legacy protocols
Command
tpad
tpad
tpad
tpad
tpad
tpad
tpad
tpad
tpad
tpad
tpad
tpad
tpad
tpad
tpad
tpad
tpad
tpad
Digi TransPort® Routers User Guide
Instance Parameter
n IPaddr
n iphdr
n termid
n dotermid
n tid
n merchnum
n useconstr
n constr
n pollchars
n domsgnb
n disdir
n bdir
n uaarc
n clear_
dirtime
n trandel
n teretran
n delstx
n no_enq
Values
IP address
0=Off
1=On
2=8583 Ascii 4 byte
text
1=enabled, 0=disabled
text
text
1=enabled, 0=disabled
text
text
1=enabled, 0=disabled
1=enabled, 0=disabled
1=enabled, 0=disabled
0-99
0-60000
0-5000
1=enabled, 0=disabled
1=enabled, 0=disabled
1=enabled, 0=disabled
Configure TPAD parameters
Equivalent web
parameter
Connect to remote IP
address.
IP length header.
Use Terminal ID (TID).
Replace TID provided by
connected terminal with
configured TID.
Use TID xxxxxxxxx with
incoming APACS 50
polling calls.
Use merchant Number.
Use Connect String.
Use Connect String.
The polling character set
is c.
Enable Message
Numbering
Disable Direct Mode.
Boot to Direct Mode.
Use response code n in
unable to authorise
message.
Clearing time n
milliseconds.
Delay transmitting the
APACS 30 string for x
milliseconds after
connecting to X.25 host.
Retransmit APACS 30
string if error detected.
STX/ETX removal.
Do not transmit ENQ
characters.
610