Digi TransPort WR11 User Manual page 568

Configuring UDP echo
Only send packet when the interface is "In Service"
When checked, and the router is using the specified interface, this setting prevents the router
from sending UDP packets if the interface is out of service.
Do not send any data with the UDP packet
When checked, causes the router to send only a single null data byte. This is useful to minimize
packet size when the interface has high data charges, such as W-WAN. When unchecked, the
router sends packets containing the router's serial number and ID as text.
3. Click Apply.
Command line
Depending on your router model, there may be instances of the UDP echo task supported by the
router. Valid instance numbers begin at 0.
Entity Instance
udpecho n
udpecho n
udpecho n
udpecho n
udpecho n
udpecho n
udpecho n
udpecho n
udpecho n
Digi TransPort® Routers User Guide
Parameter Values
dstip Valid hostname
dstport 0-65535
interval 0-2147483647
locport 0-65535
userouting off, on
ifent PPP,ETH
ifadd Valid interface
instance
0-4294967296
onlyis off, on
nodata off, on
Configure a UDP echo client
Equivalent web parameter
Send a UDP packet to IP address
a.b.c.d port n every s seconds
Send a UDP packet to IP address
a.b.c.d port n every s seconds
Send a UDP packet to IP address
a.b.c.d port n every s seconds
Use local port n
Route via Routing table
Interface x,y
Interface x,y
Only send packet when the
interface is In Service
Do not send any data with the
UDP packet
568