Configure Snmp Settings - Digi TransPort WR11 User Manual

Configuring remote management

Configure SNMP settings

É
Web
1. Go to Configuration > Remote Management > SNMP.
2. Configure the SNMP settings, as needed.
Enable SNMPv1
Enables/disables support for version 1 of the protocol.
Enable SNMPv2c
Enables/disables support for version 2c of the protocol.
Enable SNMPv3
Enables/disables support for version 3 of the protocol.
Use TACACS+ if enabled for authorisation
If enabled, the router uses TACACS to authenticate user requests, if TACACS+ is properly
configured. See
Use UDP Port n
The UDP port number to use. The default is UDP port 161.
SNMPv3 Engine ID
Required as part of the SNMP v3 protocol. This is a 24-hexadecimal character string; any
trailing zeros in this string making the value up to 24 characters can be omitted. A remote
engine ID is required when a SNMP v3 Inform is configured. The router uses the remote engine
ID to compute the security digest for authenticating and encrypting packets sent to a user on
the remote host.
3. Click Apply.
Command line
Command Instance
snmp 0
snmp 0
snmp 0
snmp 0
snmp 0
snmp 0
Digi TransPort® Routers User Guide
Use TACACS+ to control access to the
Parameter Values
v1enable on, off
v2cenable on, off
v3enable on, off
engineid String
port 0-65535
tacacs_auth on, off
Use SNMP for remote management
router.
Equivalent web parameter
Enable SNMPv1
Enable SNMPv2c
Enable SNMPv3
SNMPv3 Engine ID
Use UDP Port
Default=161
Use TACACS+ if enabled for authorisation
744