Digi TransPort WR11 User Manual page 596

Configuring legacy protocols
would not send this message, but instead wait for it to be sent to us before progressing in the
DLSw state machine.
Make immediate connection attempts before backing off
The number of successive connection attempts before backing off for the number of seconds
(default 30) defined in the Backoff for x seconds... parameter. This backoff might be
necessary when a server is behind a firewalls that detects too many successive connection
attempts in a certain time frame.
Backoff for x seconds before attempting to connect again
When backing off because of too many failed consecutive connection attempts, this parameter
defines the time, in seconds, the router should remain idle before attempting another
connection.
5. Click Apply.
Command line
Command Instance Parameter
snaip x
snaip x
snaip x
snaip x
snaip x
snaip x
snaip x
snaip x
snaip x
snaip x
snaip x
Digi TransPort® Routers User Guide
Configure Systems Network Architecture over IP (SNAIP)
Values
l1iface ISDN, Port,
SharedPort
l1nb 0–255 (Select LAPB,
Port or SharePort
instance)
protocol LAPB, SNA, RAW,
RAW_NOHDR
ans 1=enabled,
0=disabled
msn text
sub text
autocontact 1=enabled,
0=disabled
dcd_toggle 1=enabled,
0=disabled
l1oos 1=enabled,
0=disabled
master 1=enabled,
0=disabled
pollresp 0-2147483647
Equivalent web parameter
Send SNAIP traffic over interface.
Send SNAIP traffic over interface.
Use the specified protocol.
Allow this unit to answer calls.
Only accept calls with MSN ending
with the specified text.
Only accept calls with sub-address
ending with the specified text.
Assume station exists. (Do not send
TEST frames).
Toggle DCD output each time the
DLSw protocol enters the
DISCONNECTED state.
Sync port should not send or receive
data when WAN link is down.
Router to be Master on an
unbalanced link.
Polling Response Time.
596