Digi TransPort WR11 User Manual page 816

Configuring telemetry (GPS)
Active Satellites (GSA)
The NMEA text containing the number of active satellites for calculating the position.
Satellites in view (GSV)
The NMEA text containing the number of satellites in view.
Position and Time (RMC)
The NMEA text containing the current position and time.
Course over Ground (VTG)
The NMEA text containing the course data.
UTC and local date/time data (ZDA)
Displays the NMEA sentence containing the current local time and date.
All other GPS messages
The above messages are the most common and useful NMEA messages. Many GPS modules
support additional messages. Enabling this setting causes the modules to output any other
supported messages.
IP Connection 1
The router can send GPS data to up to two IP destinations. These are specified in the following
two sections of the web page.
Send GPS messages to IP address a.b.c.d
The IP address to which the GPS data should be sent.
Port n
The required TCP/UDP port number to which the GPS data should be sent.
Every n interval(s)
How often the GPS data is transmitted to the specified host.
A value of 1 transmits collected GPS data each time a UTC and local date/time data
n
(ZDA) message is received from the GPS receiver module.
A value of 2 or greater transmits every second message, and so on.
n
For this feature to work over a TCP/IP connection, you must enable the ZDA message.
Use TCP / UDP
The protocol to use for sending the messages.
Prefix the message with t
A text string that should precede the NMEA data, if desired.
Digi TransPort® Routers User Guide
Configure GPS parameters
816