Digi TransPort WR11 User Manual page 457

Configuring IP routing and forwarding
Save Config File
Saves the bgp.cnf file back to the filing system. Use if you have edited the file.
Restart BGP after configuration file is saved
When enabled, the router restarts routing using BGP after the file has been saved using the
above Save button.
Restart BGP if a fatal error occurs
When enabled, the router restarts routing using BGP if a fatal error occurs.
Advertise non-connected networks
When enabled, BGP advertises networks that exist in the BGP configuration file but that are
not actually a connected network or interface.
BGP Tracing
As with OSPF, the level of debug tracing information is selected from this drop-down list. The
available levels are; Off, Low, Med, and High.
3. Click Apply.
Command line
Command Instance Parameter
bgp 0
bgp 0
bgp 0
bgp 0
bgp 0
bgp 0
Digi TransPort® Routers User Guide
Values
enable on,off
conffile
new_cfg_rest on,off
fatal_rest on,off
allow_non_nets on,off
Default on
debug 0-3
Configure Border Gateway Protocol (BGP) settings
Equivalent web parameter
Enable BGP
BGP Configuration Filename
Restart BGP after configuration file is saved
Restart BGP if a fatal error occurs
Advertise non-connected networks
BGP Tracing
457