Digi TransPort WR11 User Manual page 362

Configuring network interfaces
second box contains the time in seconds for which the data rate must be below threshold before the
second B-channel is deactivated.
Note The following parameters are for use with Always On Dynamic ISDN.
Bring up the first ISDN B-channel
When the data rate is greater than n bytes/sec for s seconds
When Always On mode is enabled, these two settings specify the data rate and duration for which the
data rate must be sustained before the B-channel is activated.
Drop the first ISDN B-channel
When the data rate is less than n bytes/sec for s seconds
When Always On mode is enabled, these two settings specify the data rate below the traffic must fall
and the duration for which it is below the threshold before the B-channel is deactivated.
Command line
Command Instance
mlppp 0
mlppp 0
mlppp 0
mlppp 0
mlppp 0
mlppp 0
mlppp 0
mlppp 0
mlppp 0
mlppp 0
mlppp 0
mlppp 0
Digi TransPort® Routers User Guide
Parameter Values
l_accm 0x00000000-
0xFFFFFFFF
r_accm 0x00000000-
0xFFFFFFFF
username Valid username
password Valid password
epassword Encrypted
password
r_chap on, off
l_shortseq on, off
Default off
up_rate 0-2147483648
Default 2000
up_delay 0-2147483648
Default 10
down_rate 0-2147483648
Default 1000
down_delay 0-2147483648
Default 10
dup_rate 0-2147483648
Default 500
Configure PPP and external modems
Equivalent web parameter
Desired local ACCM
Desired remote ACCM
username
password
None-this parameter is not
configurable
Enable remote CHAP
authentication
Enable short sequence
numbers
When the data rate is
greater than n bytes/sec
for s seconds
When data rate is less than n
bytes/sec
for s seconds
When data rate is greater
than n bytes/sec
362